Adept Python Bedienungsanleitung PDF herunterladen (Seite 145)

Turning On Power

Adept Python Modules User’s Guide, Rev. E 145

10.3 Turning On Power

After you have made the checks listed above, you are ready to turn on system power.

1. Verify that the black circuit breaker button on the PDU3 is pressed in.

2. Turn the AC power switch on the PDU3 to the ON position.

3. Turn on DC power to the Adept SmartController.

4. The SmartController will execute its boot sequence. When the boot sequence has

completed, the OK/SF LED should be green. In addition, the status panel display

on the MB-10 should read “OK”. If the OK/SF LED is red, the SmartController

has not booted properly. Turn off power to the controller and reboot. If the

problem persists, call Adept Customer Service. Note the state of the LEDs marked

1 to 3.

5. If the HPE/ES LED is continuously red, then at least one pair of E-Stop contacts is

open. Check all E-stops.

For information on the Status LEDs, refer to the Adept SmartController User’s Guide.

10.4 Software Configuration

NOTE: Most Adept Python modules systems are shipped with the

software configuration already completed. In that case, you can proceed

directly to Section 10.5 on page 150. The information in this section is

provided for reference in case you have to perform the configuration

process.

NOTE: Remember to save all specifications to the system disk when

prompted at the end of the setup process.

DANGER: All safety systems must be in place and

operating before applying power to the system. Extra care

should be taken during the initial tests of the system.

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 169 170

Keine Kommentare

Adept Python Bedienungsanleitung Seite 145